10. REPLACEMENT AND ADJUSTMENT
3. Remove the rear cover of the copier (4 screws).
4. Open the sorter cover and remove the upper cover [A] of the sorter (3 screws).
5. Remove the front [B] and rear covers [C] of the sorter (6 screws).
6. Remove the copier main board shielding plate (2 screws).
7. Disconnect the sorter harness from CN108 [D] on the copier main board [E].
8. Swing the copier main board to the left (2 screws) and disconnect the red 2P connector
[F] and the white 4P connector [G].
9. Remove the ground wire [H] from the copier (1 screw).
10. Loosen the screws (front and rear, one each) securing the fixing brackets [I], and slide the
brackets down.
11. Remove the sorter from the copier.
14-27
31 August 1989