Ricoh FT5540 Service Manual page 232

31 August 1989
9. Assemble the pawl shaft assembly and slide it into the cleaning unit until the shaft touches
the rear side plate.
NOTE: When installing the cam holder and the cam rider, align X and Y as shown in the
figure.
Make sure that the end of the spring is in the small hole on the rear side plate.
10. Install the pawl shaft pin.
11. Push the spring collar [A] to the rear and rotate it twice as shown in the figure. Set the col-
lar on the pin [B].
NOTE: Make sure that the end of the spring is correctly positioned in the groove of the collar.
12. Reassemble.
5-21