Installation Procedure - Ricoh FT5540 Service Manual

5.2 INSTALLATION PROCEDURE

2. Turn off the main switch of the copier, and remove the rear cover (4 screws) and the cover
plate [E] (1 screw).
3. Pass the harness [F] through the hole [G]. Then, plug in the connector [H] and secure the
grounding wire [I] (1 grounding screw) as shown.
4. Pull the harness tight so that there is no slack between the menu reader [J] and the hole
[K]. Then, place the extra portion [L] of the harness neatly inside the copier.
12-9
31 August 1989