Ricoh FT5540 Service Manual page 242

31 August 1989
9. Remove the hot roller gear [A] and bearings [B] and collars [C] from both ends of the hot
roller [D] (1 C-ring each).
10. Slide the hot roller slightly to the rear and remove the hot roller as shown.
11. Tear the protective paper [E] from the ends of the new hot roller [F] and install the roller.
12. After installing the new hot roller, remove the remaining protective paper.
NOTE: When reinstalling the fusing lamp, make sure it does not touch the inside of the hot
roller.
5-31