Ricoh FT5540 Service Manual page 196

Mode No.
APS Priority:
21
Selects APS or manual.
22
SADF Shut-Off Time:
Selects shut-off time for SADF mode.
23 Free Size:
Enables originals of various sizes to be fed from
the same stack.
24 RDH/ARDF priority:
Selects RDH or ARDF.
25 Staple limit:
Sets staple limit at 35 copies.
26 Shift stack:
Shift stack mode is automatically selected when
staples run out.
27 Side erase:
Decreases side erase margins about 5mm each.
28 Sort Priority:
Sort Mode is automatically selected when more
than 1 original is set on the DF table and the
entered copy quantity is greater than 2 and less
than 20.
30 Toner Supply Mode:
Selects toner supply system.
31 Toner Supply Amount (Detect Mode):
Determines how much toner is supplied in detect
mode.
32 Toner Supply Amount (Fixed and Detect):
Determines how much toner is supplied in fixed
and detect modes.
ID Sensor Bias:
33
Sets the bias voltage applied to the bias roller for
image density sensing.
34 Bias shift:
Permanently shifts bias output.
37 Lead Edge Separation Corona timing:
Sets off-timing of the lead edge separation
corona.
Function
4-11
Data Comments
(Factory setting = 0)
0: Yes
1: N
O
0: 4 sec (Factory setting = 0)
1: 60 sec
Possible in SADF mode.
0: No
(Factory setting = 0)
1: Yes
Only if RDH/ARDF is installed.
0: RDH
1: ARDF (Factory setting = 0)
Finisher only. (Factory setting
0: Yes
1: No = 0)
Finisher only. (Factory setting
0: No
1: Yes = 0)
0: No The first LED inside each
1: Yes paper boundary turns on.
(Factory setting = 0)
1: Normal
Sorter and DF must be
installed on the machine.
1: Sort
(Factory setting = 0)
0: Detect See SP31/SP32 for ratios.
1: Fixed (Factory setting = 0)
(Factory setting = 0)
0: 30%
1: 15%
2: 45%
3: 60%
0: 7%
(Factory setting = 0)
1: 4%
2: 11%
3: 14%
0: 500 500 V = normal
470 V = light
1: 380
2: 470
380 V = lightest
530 V = dark
3: 530
(Factory setting = 0)
0: N Shifts all bias levels including
1: 60 V ID pattern bias. (Factory
2: 120 V setting = 0)
0: 10 mm Use when separation
1: 7 mm problems occur. 7 mm: -10
2: 13 mm msec. 13 mm: +10 msec.
(Factory setting = 0)
31 August 1989