Ricoh FT5540 Service Manual page 350

31 August 1989
6. Remove the receiving tray [A] and the rear cover [B] of the copier (2 screws). Swing out
the main board [C] (2 screws).
CAUTION: Be careful not to damage the fiber optics cable.
7. Remove the five plastic caps [D] from the left cover.
8. Install the two studs [E] in the lower holes [F].
9. Mount the sorter on the copier. (Insert the two mounting studs [G] into the docking holes
[H], and pass the harness [I] through the access hole [J].)
10. Fix the sorter to the copier with the spacer [K] and the knob screw [L] (front side only).
9-13