Ricoh FT5540 Service Manual page 198

Mode No.
Vsg Adjustment:
54
Turns on ID sensor LED.
Vsg/Vsp Check:
55
Displays Vsg and Vsp.
56 Auto ID Voltage Adjustment:
Automatically adjusts the auto ID reference
voltage.
57 Auto ID Voltage Value Display
Displays voltage and K values. Press Start key to
turn on. Press C/S to stop.
59 Bias Voltage:
Displays bias voltage. Press Start key to turn on.
Press C/S to stop.
Toner Density Recovery:
60
After the Start key is pressed, the toner supply
clutch turns on and free run starts. Free run stops
and constant supply is reset when Vsp becomes
1/8 Vsg.
61 Idling Period Selection:
Selects idling period at power-up.
71 Sorter/Finisher Operation:
Enables sorter or finisher operation.
72 ARDF/RDH operation:
Enables ARDF or RDH operation.
76 Sorter Bin Capacity:
Sets the stack mode quantity limit.
77
Odd Number Duplex Copy:
Sets the copler to eject the final copy if
number of originals are set.
80 Clock set:
Sets the machine clock.
Function
4-13
Data
V0: ID
pattern
V1:
Developer
bias
V0: Vsg
V1: Vsp
0: 5 min.
1: 10 min.
2: 15 min
0: NO
1: Sorter
2: Finisher
0: No
1: ARDF
2: RDH
0: No limit
1: Limit
0: Yes
an odd 1: No
31 August 1989
Comments
Adjust Vsg with VR on the ID
sensor board. LED turns on
10 sec. (no drum rotation).
Vsp/Vsg value updated every
10 copies.
Free run starts. Auto ID
adjusted automatically.
Machine starts free run.
K = SP57/SP56
Without temperature
compensation
Use this mode to bring a low
toner condition back to
normal. 100% is
selected.
(Factory setting = 0)
(Factory setting = 0)
(Factory setting = 0)
Limit = 35 sheet/bin. Use with
finisher. (Factory setting = 0)
When off, the final sheet is fed
out; when on, it stays in the
duplex tray. (Factory setting =
0)
Also accessible by the
customer using the key board.