Ricoh FT5540 Service Manual page 382

31 August 1989
9. Pull the ends of the cord to stretch it before tightening the screw and cutting off the excess
cord.
10. Remove the tape on the drive shaft and turn the drive pin [A] 330° in the direction shown in
the figure.
11. Set the drive motor worm gear [B] on the motor shaft and make sure the angle of the drive
pin is as shown in the figure [C].
12. Align the edge [D] of the paper volume sensor actuator plate with the bracket [E] as
shown and secure the actuator plate with tape [F].
10-22