Replacement And Adjustment; Bin Drive Belt Replacement - Ricoh FT5540 Service Manual

8. REPLACEMENT AND ADJUSTMENT

8.1 Bin Drive Belt Replacement

When the duplex unit is not installed, it is not necessary to perform steps 2 to 4. Note the
orientation of the flat surface on each pulley shaft before removing the drive belt.
1. Remove the sorter front [A] and rear [B] covers (2 screws each).
2. Remove the rear cover of the copier (3 screws). Then, disconnect the sorter harness (red
2p connector, white 11p connector, and white 4p connector) and the sorter ground wire.
3. Remove the knob screw [C] from the duplex unit.
4. Remove the sorter unit from the machine.
5. Remove the lower cover [D] from the sorter (2 screws).
9-15
31 August 1989