Ricoh FT5540 Service Manual page 448

31 August 1989
13. Mount the sorter on the copier through the docking holes [A].
14. Pass the sorter's harnesses through the rectangular docking hole [B].
15. Remove the main board shielding plate (2 screws) and swing the board [C] to the left (2
screws), then connect the red 2P connector [D] to the red 2P free connector and the white
4P connector [E] to the white 4P free connector.
16. Connect the harness from the sorter to CN108 [F] on the main board. Secure the ground
wire [G] as shown (toothed washer [H] is also installed for the European version).
17. Secure the sorter to the sorter adapter by fixing the brackets [I] while lifting them up (1
screw each).
18. Remount the upper, front, and rear covers.
14-23