Ricoh FT5540 Service Manual page 384

31 August 1989
5. Loosen the 2 screws securing the pinion bracket [C].
6. Loosen the screw securing the guide post lock plate [D].
7. Move the pinion bracket while holding the pinion so that the pinion does not turn. (The
front and rear guide posts must be equidistant from the center.)
8. Tighten the screws securing the pinion bracket.
9. Tighten the screws securing the guide post lock plates.
10. Confirm that the length between the guide posts [E] is within the standard value range
(297 to 299.5).
11. Confirm that the side registration is adjusted correctly and reassemble.
10-24