Camera And Monitor Setup - Ultrak CCU-100HD User Manual

CAMERA AND MONITOR SETUP

4-27
4.3.13 Camera and Monitor Setup
The Ultrak HD Video Switcher can be programmed using the CCU-100/HD
or CCU-100/HD/X Central Control Units and a KBD-100A Programming
Keyboard. The Ultrak Video Switcher has default camera titles. The camera
title is determined by the video input number the camera is connected to.
For example, the default camera title for video input 32 is CAM 32. A
camera title (one row up to 18 characters) for each video input can be
programmed and stored in the CCU-100/HD Central Control Unit. The
system date and time is displayed on each monitor. The camera title and
date and time display can be enabled or disabled. The default setting is
enabled. The position of the display on each monitor is programmable. The
default display position is on the upper left corner of the monitor screen.
The HD switcher can be programmed to monitor the video inputs for video
failure (high video, low video, sync loss). The amount of time (integration
time) the switcher monitors the video signal for a presence of high or low
video before generating an alarm is programmable from 0 to 30 seconds.
The integration setting is global for all video inputs. Loss of sync generates
an alarm immediately. The HD switcher is programmed through the CCU-
100. The video alarms can be enabled or disabled individually. The default
for video alarms is disabled. If the video alarm is disabled for a video input,
the switcher does not monitor the video signal on that input. The CCU-100
can be programmed to start a MultiCall in response to video alarms. Each
type of video alarm can be programmed to start a different MultiCall or the
same MultiCall. The CCU-100 also sends an alarm message to the HD
switcher for display on one of the system monitors. The alarm display
monitor is programmable.