Jpd-100 Function Key Or Shb-100 Function Key; Assigning Multicalls To Alarm Inputs - Ultrak CCU-100HD User Manual

ASSIGNING MULTICALLS
4-20
4.3.7.1

JPD-100 Function Key or SHB-100 Function Key

To stop a MultiCall started from a JPD-100 Function Key or SHB-100
Function Key, press the Function Key again.
4.3.8

Assigning MultiCalls to Alarm Inputs

The Central Control Unit can be programmed to assign MultiCalls to the
alarm inputs from an AIU-100 or AIF-100/IN Alarm Interface Unit, host
computer or the Ultrak HD video switcher. When the CCU receives an alarm
message, the CCU starts the MultiCall assigned to the alarm.
If the CCU has processed all the steps in the
MultiCall, pressing the function key restarts the
MultiCall.
CAUTION
Program The Alarm Monitors And VCRs
Before Assigning
Inputs. Improper System Operation May
Occur Initially
Programmed For Alarm Monitors and VCRs,
If The Alarm Monitors And VCRs Are Not
Identified. Refer To Paragraph 4.5 To
Program Alarm Monitors and Alarm VCRs.
NOTE
MultiCalls To
If Alarm Points
Alarm
Are