Table of Contents
Advertisement
1-2
• SmartScan Programming
PreShots, VectorScans, and Sector IDs stored in SmartScan assemblies are
programmed using the CCU-100 Central Control Unit, a JPD-100 Joystick
Controller, and a KBD-100A Keyboard.
Operation and Programming Manual for programming procedures.
• MultiCall Control
MultiCalls are programmed and stored in the CCU to perform one or more of the
system control functions at once, or one function at a time with dwell times
between each function.
An operator can start a MultiCall manually at a JPD-100 Controller, KBD-100A
Keyboard, or SHB-100 ShotBox.
response to an alarm or date/time.
• Time Initiated MultiCalls
The Central Control Unit is programmed to start MultiCalls, up to nine, on
selected dates at specific times. After a MultiCall is programmed to start at a
specific time, you can program it to repeat at specific intervals. This feature can
be used to accomplish fully automatic video tours at specific times of the day.
• Alarm Interface
The CCU-100/HD can receive 255 alarm inputs from AIU-100 Alarm Interface
Units, a Host Computer, or the MX-4248 I/O Module Option on the HD Series
Video Switcher. When the CCU receives an alarm, the CCU-100 starts the
MultiCall assigned to the alarm. Monitors and VCRs can be programmed as
alarm monitors and alarm VCRs. The video switched to an alarm monitor or
alarm VCR in response to an alarm is not released from the alarm device until
the alarm is acknowledged.
Refer to your specific SmartScan
MultiCalls can be started automatically in
Advertisement
Table of Contents
