Rear Panel Connector Pin-Out Assignments - Ultrak CCU-100HD User Manual

2-12
2.3.2.2

Rear Panel Connector Pin-Out Assignments

a. Channels One through Eight - Channels one through eight on the
rear panel are 6-pin DIN connectors, part number 842372-0591.
The mating 6-pin connector plugs, part number 842374-0591, are
supplied with the unit.
CHANNELS 1 THROUGH 8 PIN ASSIGNMENTS
Pin 1 TX-
Pin 2 TX+
Pin 3 GND
Pin 4 RX+
Pin 5 RX-
Pin 6 5 Vdc
If the receive (input) port is not used on
channels one through four and six through
eight, it is recommended the termination
resistor for that channel be disabled.
disable a resistor, remove the jumper for that
resistor.
Channel
1
2
Outputs data to JPD-100 Controllers,
FastScan
assemblies,
100s, and SHB-100s
Outputs data to JPD-100 Controllers,
FastScan
assemblies,
100s, and SHB-100s
Connects to cable shield
Inputs data
Controllers, AIU-100s, SHB-100s
Inputs data
Controllers, AIU-100s, SHB-100s
Optional - can be supplied through
connector J13 on the printed circuit
board.
NOTE
Termination
Resistor
R13
R14
assemblies, SmartScan
Control Receivers,
assemblies, SmartScan
Control Receivers,
from JPD-100
from JPD-100
To
Jumper
W34
W35
AIU-
AIU-
Joystick
Joystick