Ultrak CCU-100HD User Manual page 10

TERM
Sector ID Sector IDs are used for labeling specific areas that the SmartScan
unit views. Up to 16 Sector IDs can be programmed and stored in
each SmartScan unit. Sector IDs are programmed using a KBD-
100 Programming Keyboard and the JPD-100 Controller.
Whenever the dome is under manual control and viewing a
programmed sector, the sector title is added to the SmartScan
video signal. The camera ID display must be enabled for the
Sector ID title to be added to the video signal. If the SmartScan
unit is being viewed on a monitor, the label appears across the
top of the monitor in a 60 Hz system and on the bottom of the
monitor in a 50 Hz system.
MultiCall A MultiCall can be programmed to perform one or more system
functions at the same time or one function at a time with
programmable dwell times between each function. The system
functions that can be included in a MultiCall are PreShots,
VectorScans, video switching, turning on/off VCRs or other
auxiliary devices, or starting a MultiCall (including itself).
MultiCalls are used to define the system's "automatic" response to
events such as date and time, alarms, JPD-100 Controller
function keys, and SHB-100 ShotBox function keys. MultiCalls
can be started/stopped "manually" by an operator at a JPD-100
Controller or KBD-100 Keyboard. Up to 256 (00-255) MultiCalls
can be programmed and stored with a number and a 16-character
title in the CCU-100. The number is used by an operator to start
a MultiCall or assign the MultiCall to alarm inputs, function keys,
etc.
DEFINITION