Ultrak CCU-100HD User Manual page 9

The following terms are used often in this manual. Please become familiar with
them before programming and operating the CCU-100/HD or CCU-100/HD/X
Central Control Unit.
TERM
PreShot
A PreShot is a camera/lens position including pan, tilt, zoom, and
focus that is given a number and 16-character name.
number is used by the operator to send the SmartScan unit to the
PreShot position.
programmed and stored in each SmartScan unit. PreShots are
programmed using a KBD-100 Programming Keyboard and a
JPD-100 Controller. An operator sends a SmartScan unit to a
PreShot using the JPD-100 Controller or the KBD-100 Keyboard.
MultiCalls can also send cameras to PreShots.
SmartScan unit is viewing the PreShot, the title of the PreShot is
added to the video signal. If the SmartScan unit is called up on a
monitor, the title appears on the top of the monitor in a 60 Hz
system and on the bottom of the monitor in a 50 Hz system.
VectorScan A VectorScan is a video tour that is given a number and a 16-
character name. It is two or more PreShots (up to 64) from the
same SmartScan unit linked together with specified dwell times.
Up to ten (0-9) VectorScans can be stored in each SmartScan
unit. The number is used by the operator to start the VectorScan.
VectorScans are programmed using the KBD-100 Keyboard and
the JPD-100 Controller.
operator using the JPD-100 Controller or KBD-100 Keyboard.
VectorScans can also be started in a MultiCall.
VectorScan is running in a SmartScan unit, the title of the PreShot
currently being viewed is added to the SmartScan video signal.
DEFINITIONS OF TERMS
DEFINITION
Up to 100 (00-99) PreShots can be
They can be started/stopped by an
The
When the
When a