Table of Contents
Advertisement
ASSIGNING MULTICALLS
4-22
6.
Press ENTER when done assigning MultiCalls to alarms.
7.
Perform steps 3 and 4 above to program more alarms or press Esc to
end Programming.
4.3.9
Assigning MultiCalls to SHB-100 Function Keys
The CCU can be programmed to assign MultiCalls to SHB-100 Function
Keys.
assigned to the key. When the function key is pressed again, the CCU stops
processing the MultiCall assigned to the key.
Perform the following steps to assign MultiCalls to SHB-100 function keys
(quick switches).
1.
Press Shift F10.
2.
Press Q on the KBD-100A keyboard.
3.
Enter the address (0-15) of the SHB-100 to be programmed.
Each SHB-100 contains 16 function keys (quick switches). The NUM
column is the function key number and the MC column is the MultiCall
Number (0-255).
4.
Use the gray arrow keys to move around in the table to assign a
MultiCall to the desired function key.
To unassign (remove) a MultiCall from a function key, press the space
bar until the MultiCall number is erased.
5.
Press Enter when done.
6.
Enter the address of another SHB-100 or press ESC to end
programming.
To delete MultiCalls from alarms, press the space bar until the
MultiCall number is erased.
When the function key is pressed, the CCU starts the MultiCall
Advertisement
Table of Contents
