A.1
GENERAL
Prior to programming the CCU-100, identify all pieces of equipment and their
addresses in your specific system.
Refer to the following paragraphs for assistance in identifying equipment addresses.
A.1.1
JPD-100 Joystick Controllers
There are four possible joystick controller addresses, 0-3.
JPD 0
JPD 1
JPD 2
JPD 3
A.1.2
AIU-100 Alarm Interface Unit
There are eight possible AIU-100 addresses (numbers), 0-7. The address is set
by a 3-position DIP switch, S5, inside the AIU-100.
The following table identifies the switch setting for the corresponding AIU-100
address.
APPENDIX A. SYSTEM CONFIGURATION
Front Panel
Channel 1
Channel 2
Channel 3
A-1