Table of Contents
Advertisement
A-4
A.1.4
Camera Numbers
The HD video switcher supports 128 cameras. The camera address and the video
input number should be the same. The camera address on FastScan/SmartScan
units is set using an 8-position DIP switch or three rotary switches on the Digital
Receiver Board. Refer to your specific FastScan/SmartScan Installation Manual
for setting camera addresses.
A.1.5
Monitor Numbers
The JPD-100 controller recognizes 32 monitors and the HD switcher is
expandable to 32 monitors. The base HD switcher has eight video outputs. The
monitor numbers are identified by the video output channel used on the switcher.
A.1.6
VCRs
The VCR number is identified by the video output used on the switcher.
A.1.7
Alarm VCR On/Off Control
The alarm VCR On/Off Control is designed for use with the optional MX-4248 I/O
module on the HD series video switcher.
Output Control Data out COM2.
The CCU sends alarm VCR Contact
Advertisement
Table of Contents
