V - Vectorscan - Ultrak CCU-100HD User Manual

PROGRAMMING MULTICALLS
4-10
4.3.3.2

V - VectorScan

To program the MultiCall to perform a VectorScan, perform the following
steps.
1.
2.
3.
4.
5.
If the cursor does not automatically move to
the next field after entering data in a field,
press the gray right arrow key to move to the
next field.
Enter a V in the FUN field.
Enter the VectorScan Number (0-9) in the NUM field.
Enter the Camera Number (1-128) where the VectorScan is stored
in the CAM field.
Enter a Dwell Time (00-99 seconds) in the DWELL field. Dwell
time is the amount of time you want the CCU to wait before it
performs the next step in the MultiCall. A "00" dwell time tells the
CCU to perform the functions at the same time. A "15" second
dwell time means that the CCU will wait 15 seconds before
performing the next step in the MultiCall.
Enter another function or press Enter to end programming. If you
pressed Enter, press S to save programming or press Esc to end
programming without saving.
NOTE