Table of Contents
Advertisement
4.3
PROGRAMMING THE CCU-100/HD CENTRAL CONTROL UNIT
A JPD-100 Joystick Controller, a KBD-100A Keyboard, and a Diamond Series
SmartScan unit are required to program the CCU-100/HD Central Control Unit.
The KBD-100A and the JPD-100 must be plugged into the front panel of the
CCU-100. The JPD-100 Joystick Controller must have a SmartScan unit called
up as the primary control camera. The camera must be called up on a monitor
that can be viewed by the programmer. The programming menus are generated
by the character generator on the SmartScan receiver board and added to the
video signal of the SmartScan unit.
Battery Backup
The CCU has battery backup so all programming is protected if the system loses
power. The CCU has a jumper, W44, on the printed circuit board inside the
chassis. Jumper W44 must be installed to enable the battery backup and is
removed to disable battery backup. To ensure the backup is enabled, perform
the following steps. Note: This procedure should only be performed by a
qualified technician.
1.
Program a single step MultiCall and save it.
2.
Turn off the CCU.
3.
Turn on the CCU.
4.
If the MultiCall is present, battery back up is enabled. If the MultiCall is not
present, the jumper may not be installed. Perform the following steps to
install jumper W44.
a.
Remove power from the CCU.
b.
Remove the chassis cover from the CCU.
c.
Install jumper W44.
d.
Replace the chassis cover.
e.
Turn on the CCU.
f.
Perform steps 1 through 4 again.
PROGRAMMING THE CCU-100/HD
4-3
Advertisement
Table of Contents
