Ultrak CCU-100HD User Manual page 52

3-2
address 1 is sent out COM 2 to the video switcher. Auxiliary control data for
all other addresses is sent out channels 4 and 6.
a. JPD-100 Function Keys
Each JPD-100 Controller has 8 programmable function keys. Each
function key is designed to perform one or more SmartScan system
actions using a single key stroke.
PreShots, VectorScans, Video Switching, Auxiliary Control, and
MultiCall Control. These actions can be performed simultaneously or
one step at a time with programmable dwell times between each step.
To program the function keys, the user must program a MultiCall to
perform the desired system actions and store it in the CCU.
MultiCall is then assigned to the function key on the JPD-100. When
the operator presses the function key on the JPD-100, the CCU sends
out the actions stored in the MultiCall to the system. If the operator
presses the function key again, while the MultiCall is in process, the
CCU stops processing the MultiCall.
b. JPD-100 LCD Display
Each JPD-100 Controller displays the control camera and monitor. The
CCU updates the second line of the LCD display to show the oldest
standard alarm and the oldest video alarm in the system (if applicable).
1. Camera/Monitor Display
Each JPD-100 Controller displays its control camera and monitor.
When more than one JPD-100 is connected to the CCU, the CCU
keeps the LCD display on all the JPD-100 Controllers updated to
show the correct camera/monitor combination and displays the
oldest alarm number. If a user changes the camera on a monitor,
The system actions include
The