Table of Contents
Advertisement
PROGRAMMING MULTICALLS
4-6
4.3.2
List Programmed MultiCalls
Perform the following steps to list the programmed MultiCalls.
1.
2.
4.3.3
Programming MultiCalls
To program a MultiCall, perform the following steps.
1.
Press SHIFT F11 on the KBD-100A keyboard.
2.
Enter the desired MultiCall number (00-255) to program.
3.
Enter the desired title for the MultiCall
4.
Enter the desired functions in the order you want the MultiCall to
perform them. Note: the first step is 00.
If all the functions are to be performed simultaneously, the order they
are entered does not matter unless the cameras are called to alarm
monitors and alarm VCRs. If these functions are used, they must be the
first steps in the MultiCall and all but the last step involving alarm
monitors and alarm VCRs must have a zero dwell time.
Press F11.
Each time function key F11 is pressed, the next page of MultiCalls
is displayed. An "End of List" message appears at the bottom of
the last page. To return to the first page, press F11.
Press Esc when done viewing the list.
All commands are entered using the KBD-
100A keyboard.
NOTE
Advertisement
Table of Contents
