Sample System Programming - Ultrak CCU-100HD User Manual

SAMPLE SYSTEM PROGRAMMING

4-34
4.5 SAMPLE SYSTEM PROGRAMMING
The following examples provide some typical situations and the methods used
for programming the system's responses.
All of the examples require a CCU-100 Central Control Unit, a KBD-100A
Keyboard, and a JPD-100 Controller. For the following examples, a JPD-100
Controller and the KBD-100A keyboard are both plugged into the front panel of
the CCU.
A. Jewelry Store with One Entrance/Exit
This system requires alarm inputs so an AIU-100 or AIF-100/IN Alarm
Interface Unit is required.
Scenario: The store manager wants to view all customers entering/exiting
When a person passes through the entrance, a sensor sends an alarm to
the system. The alarm is assigned to a MultiCall that sends a SmartScan
unit mounted in the ceiling near the entrance to view the entrance, calls the
video from the SmartScan unit up on the monitor and VCR in his office, and
records the video for 10 seconds. After taping the entrance for 10 seconds,
the system automatically acknowledges the alarm. When the alarm record
(AR) function is used, acknowledging the alarm returns the contact output
(VCR) to its state before the MultiCall was started. The MultiCall does not
need a line to turn the contact output (VCR) off.
Perform the following steps to program the system to respond as described
above.
the store on a monitor in his office and tape the video for 10
seconds as well.