Table of Contents
Advertisement
4.3.10
Assigning MultiCalls to JPD-100 Function Keys
The CCU can be programmed to assign MultiCalls to JPD-100 Function
Keys.
assigned to the key. When the function key is pressed again, the CCU stops
processing the MultiCall assigned to the key.
To assign MultiCalls to JPD-100 function keys, perform the following steps.
1.
Press Shift F10.
2.
Press J on the KBD-100A Keyboard for JPD-100 JPD Quick Switch
3.
Enter the address of the JPD-100 to be programmed
There can be up to four JPD-100 Controllers (0 through 3). The JPD-
100 front panel connection is JPD 0 and channels 1 through 3 on the
rear panel of the CCU-100 are JPD 1 through 3, respectively. Each
JPD-100 contains eight (8) function keys (quick switches).
The NUM column is the function key number and the MC column is the
MultiCall Number (0-255).
4.
Use the gray arrow keys to move around in the table to assign a
MultiCall to the desired function key.
To unassign (remove) a MultiCall from a function key, press the space
bar until the MultiCall number is erased.
5.
Press Enter when done.
6.
Enter the address of another JPD-100 or press ESC to end
programming.
When the function key is pressed, the CCU starts the MultiCall
ASSIGNING MULTICALLS
4-23
Advertisement
Table of Contents
