Table of Contents
Advertisement
PROGRAMMING THE CCU-100/HD
4-4
Restoring Factory Default Settings
This same jumper, W44 can be used to restore the CCUs default settings as
shipped from the factory. Note: This procedure should only be performed by
a qualified technician.
1.
Power down the CCU.
2.
Remove the chassis cover from the CCU.
3.
Remove the battery back up jumper W44. Wait approximately 10
seconds or longer.
4.
Reinstall jumper W44.
5.
Replace the chassis cover on the CCU.
6.
Reapply power to the CCU.
WARNING
ALL
USER
PROGRAMMING
SETTINGS, MULTICALLS,
MENTS) STORED IN THE CCU WILL BE
LOST IF YOU PERFORM THE FOLLOWING
PROCEDURE.
(SYSTEM
AND ASSIGN-
Advertisement
Table of Contents
