A - Auxiliary Output Control (Such As Vcrs) - Ultrak CCU-100HD User Manual

PROGRAMMING MULTICALLS
4-16
4.3.3.5

A - Auxiliary Output Control (such as VCRs)

The auxiliary output control function is used to energize or de-energize
relays to turn on or off auxiliary devices such as VCRs. The auxiliary
devices must be connected to a unit that contains contact outputs for
this purpose. The HD series video switcher has eight optional auxiliary
outputs, the AIF-100/CO has eight auxiliary outputs, the CRX-800 Series
Control Receivers have six auxiliary outputs and CRX-500 Series
Control Receivers have two auxiliary outputs. To control an auxiliary
device, the programmer must know the address of the contact output
device (AIF-100/CO, or CRX-800) and the number of the contact output
the auxiliary device is connected to. The addresses of the AIF-100/CO,
CRX-500, and CRX-800 units are DIP switch selectable like the
FastScan/SmartScan units.
relay contacts on the HD series video switcher is one (1).
To program the MultiCall to turn an auxiliary device on or off, perform
the following steps.
1.
2.
3.
Enter A in the FUN field.
Enter the auxiliary number in the NUM field.
The auxiliary number is the physical contact output on the unit the
auxiliary device is connected to.
Enter the address of the auxiliary device (AIF-100/CO, the CRX-
800 Series Receiver, or CRX-500 Series Receiver, HD switcher) in
the CAM field. Note: The address of the HD switcher is always
one (1).
The address for controlling the optional