Table of Contents
Advertisement
SECTION 2. INSTALLATION AND INTERCONNECTIONS
2.1
GENERAL
This section describes the cabling requirements, DIP switch and jumper settings,
the connector pin-out assignments, and the equipment connections for the CCU-
100/HD or CCU-100/HD/X Central Control Unit.
2.2
SETUP
The CCU has jumpers and DIP switches inside the chassis on the printed circuit
board that set up the operation of the unit. The following settings describe the
standard setup.
2.2.1
DIP Switches
The CCU has five 8-position DIP switches, S1-S5, for setting up the unit.
The chassis cover has to be removed to set the DIP switches.
CAUTION
Internal Settings Are To Be Set By Qualified
Technical Personnel Only. Ensure Power Is
Removed From Unit Before Chassis Cover
Is Removed.
2-1
Advertisement
Table of Contents
