Equipment Interconnections - Ultrak CCU-100HD User Manual

2-14
2.3.2.3

Equipment Interconnections.

The following paragraphs and illustrations define the specific equipment
connections for each channel.
•
Pin 2
Pin 3
Pin 7
Channels 1, 2, and 3
Channels one through three are for connection to JPD-100 Joystick
Controllers. This is a duplex RS485 communication link.
controllers can operate to a maximum distance of 4000 feet from
the CCU-100 Central Control Unit using the recommended cable.
A DIA-01 or DIA-01/X control interface adapter is required to
connect a JPD-100 Controller to a channel on the rear panel of the
CCU. The control interface adapter has a 5 Vdc plug-in power
supply required to operate the JPD-100 Controller and a 6-wire
modular-type telephone jack for connection to the Central Control
Unit rear panel.
channels 1, 2, and 3.
COM 2 PIN ASSIGNMENTS
TX
RX
GND
See Figure 2-3 for a typical installation for
Output data
Input data
The