Table of Contents
Advertisement
VJ-1608 Hybrid INSTALLATION MANUAL
5 Connecting the power cable
This section explains how to connect the power cable.
WARNING
Make sure that the included power ca-
ble is used.
If other power cables are used, it may
cause an electric shock or fire.
Do not use a damaged power cable.
It may cause an electric shock or fire.
Follow the steps below to connect the power cable.
1. Confirm that the printer is turned OFF.
NOTE
If the [Power] key is pressed, the printer is turned
ON.
Press the key again, and turn OFF the power.
2. Connect the power cables (x 2) to the AC inlets (x 2)
on the right of the printer.
1
2
No.
Name
No.
2
1
AC inlet
3. Correctly insert the power cable plug into the power
socket.
NOTE
To use the two power cables plugged in the inlets,
a total capacity of 18.5 A or over is required.
If the power source cannot supply the required ca-
pacity, plug the two power cables in the different
power sources respectively.
1
No.
Name
1
Power cable
VJ1608HYE-I-00
6 Turning the power ON/OFF
This section explains how to turn ON/OFF the printer.
6.1 Turning the power ON
Follow the procedure below to turn ON the printer.
1. Press the [Power] key on the operation panel to
turn ON the printer.
The Power lamp on the operation panel lights up
in green.
The printer starts initial operation.
When the initial operation is complete, the printer
enters normal status.
6.2 Turning the power OFF
Follow the procedure below to turn OFF the printer.
1. Verify the following regarding the operational con-
dition of the printer.
Printing or other operations are not in progress.
The operation panel is in normal status.
2. Press the [Power] key on the operation panel to
turn OFF the printer.
NOTE
If the operation panel is in the following status, the
power is ON.
The [Power] key is pressed in.
The Power lamp lights up in green.
Press the key once again and turn OFF the power.
Name
Power cable
"CR Mainte.: Start" is displayed on the operation
panel.
3. Press the [Enter] key on the operation panel.
Maintenance starts.
The print head moves to the left.
The cleaning wiper moves forward.
"CR Maintenance: Wiper End" is displayed on the
operation panel.
4. Clean the cleaning wiper unit.
5. Clean around the print head.
6. After cleaning is completed, press the [Enter] key
6
Operation Manual "6.2.4.1 Cleaning the
cleaning wiper unit"
Operation Manual "6.2.4.2 Cleaning around
the print head"
TIP
Press the [Cancel] key if cleaning the cleaning wiper
unit and around the print head is not performed.
on the operation panel.
The cleaning wiper returns to its original position.
The print head returns to its original position.
The printer starts the procedure to turn the power
OFF.
"Power Off" is displayed on the operation panel.
All the lamps on the operation panel and the LCD
monitor are turned OFF.
The printer automatically turns the power OFF.
NOTE
If there is a problem during turning OFF opera-
tion, a message is displayed on the operation panel
and the printer may stop operating.
If operation stops, refer to Operation Manual
"7 Troubleshooting" and deal with the problem.
After turning OFF the printer, wait for 10 seconds
or longer to turn it ON again.
Advertisement
Table of Contents
