8.4 WHEN MEDIA JAMS OCCUR
If the loaded media gets jammed in the printer, follow the steps below to remove the media.
8.4.1 How to remove a piece of media (sheet media)
Step 1 :
Press [F4] to raise the pressure rollers.
Step 2 :
The MEDIA SET lamp will switch ON (orange).
Notes
F
OR RAISING OR LOWERING THE PRESSURE ROLLERS
.
PANEL
Step 3 :
If a piece of media or media dust is stocked in the printer, open the front cover and remove the
piece of media or media dust.
Caution
B
E SURE NOT TO PINCH YOUR FINGERS WHILE OPENING AND CLOSING MEDIA COVER
Step 4 :
If there is an error requiring a restart, power the printer OFF and ON again.
8.4.2 How to remove a piece of media (roll media)
To remove a piece of roll media, please refer to the User's Guide "Handling roll media".
,
YOU CAN USE THE FOOT SWITCH INSTEAD OF THE OPERATION
141
User's Guide Blizzard
Chapter 8: Troubleshooting
.
AP-75260 – Rev. 2.1 – 15/01/08