Setting The Quality [Quality]; Thick Mode Settings - GRAPHTEC CUTTING PRO FC2250 Series User Manual

Table of Contents

Advertisement

Chapter 3 PREPARATIONS FOR CUTTING/PLOTTING

Setting the Quality [QUALITY]

This setting determines the quality of the cut or plotted results. Please see Section 3.10, "Media and Cutting
Conditions" for further details on the setting values.
(1) With the plotter in Ready status, press a key from [F1] to [F4] to select the COND No. that you wish to change.
(2) Press the [CONDITIONS] key to display the following screen. (The display will differ according to the setting
conditions that have been made.)
FORCE
X20 COND1
30 CHANGE TOOL1
SPEED
(3) Press the [F4] key to move the blinking cursor to the QUALITY parameter.
FORCE
X20 COND1
30 CHANGE TOOL1
SPEED
(4) Use the [
] or [
Setting range: 1-6
The smaller the number, the higher the quality
(5) When the displayed settings are correct, press the [ENTER] key. To cancel your settings, press the [NEXT] key.

Thick Mode Settings

The Thick Mode is used for cutting thick media such as rubber for sandblasting masks and thick paper for
garment patterns as well as hard media such as acrylic film. This setting is only enabled for the COND Nos.
to which THICK mode has been assigned.
Thick Mode is not enabled when "PEN" or "CP001" has been selected as the cutter blade type.
Please see Section 5.7, "Assigning Thick Mode" for further details.
(1) When Thick Mode has been specified, the blinking cursor is displayed located over the Tool No. when the plotter is
in Ready status.
FORCE
20,20 COND1
30
READY+ TOOL1
SPEED
(2) Press the [CONDITIONS] key to display the following screen. (The display will differ according to the setting
conditions that have been made.)
FORCE
X20 COND1
30 CHANGE TOOL1
SPEED
(3) Press the [ENTER] key to display the Thick Mode mode selection screen (only when thick mode assignment has
been performed).
FORCE
•MODE
STR.=0.0mm END=0.0mm
SPEED
3-14
OFFSET
09U 0
4
QUALITY
OFFSET
09U 0
4
QUALITY
] key to change the value.
OFFSET
09U 0
4
QUALITY
OFFSET
09U 0
4
QUALITY
OFFSET
THICK MODE2
QUALITY

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the CUTTING PRO FC2250 Series and is the answer not in the manual?

Table of Contents