Paper Feed Section; Removing The Forwarding Pulley; Detaching And Refitting The Forwarding, Paper Feed And Separation Pulleys - Kyocera KM-3050 Service Manual

1-5-2

Paper feed section

(1) Detaching and refitting the forwarding, paper feed and separation pulleys

Follow the procedure below to replace the forwarding, paper feed and separation pulleys.
Procedure
Removing the primary paper feed units
1. Open the front cover and pull out the cas-
settes 1 and 2.
2. Remove the screw and remove the primary
paper feed unit.

Removing the forwarding pulley

3. Remove the stopper from the primary paper
feed unit.
4. Raise the forwarding pulley retainer in the
direction the arrow, and remove from the pri-
mary paper feed unit.
5. Remove the stop ring from the forwarding
pulley retainer.
6. Remove the forwarding pulley from the for-
warding pulley shaft.
Primary paper feed unit
Figure 1-5-3
Forwarding pulley
retainer
Figure 1-5-4
Forwarding
pulley shaft
Forwarding pulley
Figure 1-5-5
2GN/2GP/2GR
Stopper
Forwarding pulley retainer
Stop ring
1-5-3