Ring Times; Codes; User Code And Code Commands - Bosch ICP-AMAX4-P1 Installation Manual

42 en | Settings
If the AMAX panel got the [#] acknowledgement from the user, it will send 2 seconds long
beep as acknowledge tone and hang up the line.
7.1.8

Ring Times

Ring Count
This address sets the number of rings before the AMAX panel answers an incoming call.
Setting this count to an acceptable level has an effect only if remote arming and remote
upload / download are enabled. Programming this address to 0 prevents the AMAX panel from
answering incoming calls regardless of any other programmed options.
7.2

Codes

The AMAX system provides two types of access codes, the installer codes and user codes.
Each of them allows specific access and operation of the AMAX panel functions.
7.2.1

User Code and Code Commands

User codes and installer codes allow executing the following programming and operating
commands.
Notice!
No identical user codes are allowed. User codes are not permitted to be the same as installer
codes. The installer commands can be used only when all areas of the system are in
disarming status with no alarm activated and when installer access is enabled from user.
2014.4 | 01 | F.01U.267.112 Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitssysteme GmbH
EN