Sirens; Rf Devices; Rf Options - Bosch ICP-AMAX4-P1 Installation Manual

72 en | Settings
Output
Mode
Output
Time
* AMAX 2100 areas 1 - 2 zones 1 - 8
AMAX 3000 areas 1 - 8 zones 1 - 32
AMAX 4000 areas 1 - 16 zones 1 - 64
Output Mode
Three different polarities are available.
0 - Continuous output
Output state is continuous, level is high.
1 - Pulse output
This polarity is a pulse output, period is 1 second.
2- Inverted
Output state is continuous, level is low (level is high in idle state). When PO-1 or PO-2 is set to
inverted, then for these outputs supervision is disabled.
Output Time
Each output is for a specific time and resets at the end of output time.
The actual output time of system audio alarm, system alarm, and follow zone event is related
to the ringing of the alarm siren.
7.6.2

Sirens

Alarm Siren Ringing Time
The alarm siren ringing time is valid only when the keypad alarm tone is enabled. When there
is audio alarm in the system, the alarm siren begins to ring. After valid arming / disarming
command, alarm reset or alarm siren ringing time ends and the alarm siren stops ringing.
For programming of alarm time, see On board Output Programming.
Beep For Warning Devices
Enables / disables beep for warning devices when the system is armed, disarmed, or during
walk test.
Internal Siren Beep as Indication
Enables / disables internal siren beep as indication when the system is armed, disarmed, or
programming mode is entered.
Silence Warning Device When Disarmed
Enables / disables silence warning device when disarmed or by pressing any key.
7.7

RF Devices

7.7.1

RF Options

RF Receiver Functionality
Enables or disables RF receiver functionality.
2014.4 | 01 | F.01U.267.112
30 Walktest
0 Continuous output
1 Pulse
2 Inverted
000 - 0 - 999 seconds
999
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitssysteme GmbH
EN