Battery Installation - Bosch ICP-AMAX4-P1 Installation Manual

24 en | Installation
Figure 6.2: Enclosure / with mounting plate
Expansion modules can be placed in enclosure of the AMAX panel. Several places are
available. Figure 6.1. shows standard enclosure installation and enclosure installation with
mounting plate.
6.2

Battery Installation

The AMAX Panel supports one sealed lead-acid rechargeable battery. After the battery is fully
charged, it can be used as backup power supply to support the system.
Please refer to , page 151
Danger!
Special care is required in connecting the positive (red) wire and the "BATT +" port of the
AMAX panel. If you short-circuit the "BATT +" port of the AMAX panel or the enclosure, an
electric arc will occur. To remove the battery from the AMAX panel, the positive wire of the
battery should be disconnected first.
1.
2.
3.
4.
Once the installation is complete, the AMAX panel will begin to charge the battery.
2014.4 | 01 | F.01U.267.112
Place the battery on the bottom of the enclosure.
Position the red and black wires.
Connect one end of the black wire to the "BATT -" port of the AMAX panel, and the other
end to the negative (-) pole of the battery.
Connect one end of the red wire to the "BATT +" port of the AMAX panel, the other end to
the positive (+) pole of the battery.
1
E N √
Installation Guide
AMAX panel 4000 / AMAX panel 4000
Bosch Sicherheitssysteme GmbH
EN