Pc Programming - Bosch ICP-AMAX4-P1 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
Notice!
For LED / Icon LCD keypad, when the programming data exceeds the display range of the
keypad indicator, then there will be no display on the keypad.
8.2

PC Programming

AMAX panel supports remote programming via USB, telephone, or IP network using software
A-Link Plus.
–
–
–
Common settings for all types of connections
Select index sheet "Control Panel Configuration".
Control Panel Type
Select type of AMAX panel
Subscriber Number
Make sure that the value for destination 1 is the same as currently programmed in AMAX panel
as receiver 1. The value is 000000, when firmware of the AMAX panel was upgraded or the
AMAX panel has factory settings. Refer to , page 86
Installer code
Select item "system options" in the same index sheet. Make sure that the value for parameter
"installer code" is the same as currently programmed in the AMAX panel. The value is 1234,
when firmware of the AMAX panel was upgraded or the AMAX panel has factory settings. Refer
to , page 87
Bosch Sicherheitssysteme GmbH
11 X
12 X
13
14
15
Uploading / downloading programming parameters
Remote arming / disarming of each area
Enabling / disabling the alarm siren of each area and output
X
X
X
Installation Guide
Configuration | en 85
X
X
X
X
X
2014.4 | 01 | F.01U.267.112