Code Permissions; Zones; Add / Delete Zone - Bosch ICP-AMAX4-P1 Installation Manual

AMAX panel 4000 / AMAX panel 4000
EN
Single-Button arm / disarm
Keyswitch arm / disarm
7.2.5

Code Permissions

Tamper Reset by User
The AMAX panel may allow tamper reset by user code. If this option is disabled, the installer
code only may perform tamper reset.
Arm / Disarm Installer
The AMAX panel may allow arm / disarm by using the installer code. If this option is disabled,
the installer code is not allowed to perform arm / disarm.
7.3

Zones

7.3.1

Add / Delete Zone

Based on zone numbers, when adding or changing each zone, it is required to specify the area,
select the zone functions and select the module of zone source.
When the zone is selected to 0, i.e., the zone is not used, any address set on the zone function
and module selection are invalid.
Zone Module
The AMAX panel supports onboard zones, keypad zones, AMAX 3000 / 4000, and DX2010
zones and RF zones.
Zone Function / Type
Zone Function Option
Zone Type
Bosch Sicherheitssysteme GmbH
Description
00 Zone not used
01 Instant
02 Interior instant
03 Delay
04 Interior delay
05 Follower
06 Interior follower
07 24-hour
08 Key-switch toggle
09 Key switch on / off
10 24-hour panic
11 24-hour fire
12 24-hour fire with verification*
13 Tamper
14 Bolt contact
15 External fault
Installation Guide
Report = 253
Report = 254
2014.4 | 01 | F.01U.267.112
Settings | en 47