Keypads And Areas; Keypad Area - Bosch ICP-AMAX4-P1 Installation Manual

60 en | Settings
In a multi area system the following table shows area assignment and keypad indication of
zones:
Zone Number
7.4

Keypads and Areas

7.4.1

Keypad Area

Master Keypad
User access to a master keypad differs from user access to an area keypad. The master keypad
switches to the master keypad mode or to the area that the user declares after entering the
user code.
The AMAX panel supports master keypads. The arming / disarming, area alarm, AC power fault,
system fault and system event of each area can be displayed on the master keypad. It is not
possible to execute arming / disarming and bypass operation on the master keypad. When
relevant operations are made to the area, the master keypad should be switched to the
corresponding area.
Area Keypad
It is possible to operate each area with a single or multiple independent keypads.
Each area keypad can only operate the corresponding area of the programming,
When the area keypad has not corresponding zones, the area keypad cannot be used to
execute zone-related operations such as arming / disarming and bypass, but can be used to
execute operations without relations to the zone, e.g. event inquiry.
Each area keypad can display the status of the zone belonging to the area. However, for IUI-
AMAX3- LED8 keypad, IUI-AMAXLED 8 keypad and IUI-AMAX-LCD 8 keypad, each area can
display up to 8 zones and cannot display other zones, but can report zone events. For IUI-
AMAX3LED16 keypad, each area can display up to 16 zones and cannot display other zones,
but can report zone events. Keypad IUI -AMAX4-TEXT can display up to 64 zones.
2014.4 | 01 | F.01U.267.112
Area
1 2
2 2
3 1
4 1
5 1
6 1
7 2
8 2
9 2
10 2
11 1
12 1
Installation Guide
Indication keypad area 1
1
2
3
4
5
6
AMAX panel 4000 / AMAX panel 4000
Indication keypad area 1
1
2
3
4
5
6
Bosch Sicherheitssysteme GmbH
EN