Bosch ICP-AMAX4-P1 Installation Manual page 141

AMAX panel 4000 / AMAX panel 4000
EN
Communication with DX3010 is normal and fault is reset.
Supervise:
1.
2.
3.
–
Condition:
No communication with DX2010 if DX2010 is programmed.
Restore:
Communication with DX2010 is normal and fault is reset.
Supervise:
1.
2.
3.
–
Module 4010 Missing
Condition:
No communication with DX4010 if printer is enabled.
Restore:
Communication with DX4010 is normal and fault is reset.
Supervise:
1.
2.
3.
Printer Missing
Condition:
No communication with printer, if printer is enabled and the DX4010 is normal.
Restore:
Communication with printer and DX4010 are normal and fault is reset.
Supervise:
1.
2.
3.
Printer Fault
Condition:
The printer is abnormal (e.g., printer no paper / printer buffer is overflow / ...) if printer is
enable and the DX4010 is normal.
Restore:
The printer and DX4010 are normal and fault is reset.
Supervise:
1.
2.
Bosch Sicherheitssysteme GmbH
Report the DX3010 fault to configured destination on address 140 when the fault is
detected.
Slow flash FAULT indicator (refer to Keypad Indicators for the detailed description).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off, when there is no other system fault.
Input Expansion Module Failure
Report the DX2010 fault to configured destination on address 140 when the fault is
detected.
Slow flash FAULT indicator (refer to Keypad Indicators for the detailed description).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off, when there is no other system fault.
Printer Failure
Report the DX4010 missing fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators for the detailed description).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off, when there is no other system fault.
Report the printer missing fault to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators the detailed description).
When the fault is reset, send the restored report to the configured destinations. The
FAULT indicator is turned off, when there is no other system fault.
Report the printer error to configured destination when the fault is detected.
Slow flash FAULT indicator (refer to Keypad Indicators the detailed description).
Installation Guide
Troubleshooting | en 141
2014.4 | 01 | F.01U.267.112