Bosch ICP-AMAX4-P1 Installation Manual page 83

AMAX panel 4000 / AMAX panel 4000
EN
7 RF MANAGER
Figure 8.7: RF Setting
(**) Select method for entering KEYFOB ID: press * key 3 seconds in order to toggle between
MANUAL and AUTO.
MANUAL
AUTO
Bosch Sicherheitssysteme GmbH
RF SETTINGS
RF RECEIVER
RF RECEIVER ENABLE
RF SUPERVISION
RF DEVICE SUPERV:
RF JAM DETECT LEV.
SIGNAL JAM DETECT:
RF LOW BATT REPEAT
LOW BATT. REPEATE:
SIREN BEEP ARM/DIS
SIREN BEEP ARM/DIS
RF KEYFOB PANIC AL
RF ZN MISSING = AL
RF DEVICES / USER
RF USER
KEYFOB No: 1-128
KEYFOB ID: MANUAL
KEYFOB ID:
RF REPEATER
REPEATER No: 1-8
REPEATERID: MANUAL
REPEATER ID: AUTO
RF SENSOR DIAGNOSE
RF ZONE No:
RF REPEATER DIAGN.
REPEATER No: 1-8
CLR ALL RF DEVICES
CLEAR CONFIRM
CLEAR CANCEL
Type 9-digit value for RFID. Press # to confirm.
Press Keyfob button and wait until KEYFOB ID is displayed by the system. Press #
to confirm.
0 = disabled 1 = enabled
0 = disable 1 = 20min 2 = 1h 3 = 2,5h 4 = 4h 5 = 12h 6 = 24h
0 - 15 0 = most sensitive
0 = disabled 1 = 4h 2 = 24h
0 = disabled 1 = enabled
0 = No alarm 1 = Silent alarm 2 = Non silent alarm
0 = disabled 1 = enabled
1 - 8
_ _ _ _ _ _ _ _ _ 9 Digits
AUTO
Device must be triggered, RF ID will be entered
1 - 128 (for keyfob assignement to areas refer to installation guide)
_ _ _ _ _ _ _ _ _ 9 Digits
Device must be triggered, RF ID will be entered
1 - 64
1 - 8
Installation Guide
Configuration | en
press* 3 sec for AUTO
press* 3 sec for MANUAL
press* 3 sec for AUTO
press* 3 sec for MANUAL
99 / 1 Signal/noise (>40) / (signal-noise = >20)
eg 40/20=OK 80/60=OK 40/30=relocate 95/80=relocate
99 / 1 Signal/noise (>40) / (signal-noise = >20)
eg 40/20=OK 80/60=OK 40/30=relocate 95/80=relocate
2014.4 | 01 | F.01U.267.112
83
default
[0]
EN=1 [1]
[12]
[1]
[1]
[2]
EN=0 [1]