Monitor Panel - Regal 53 SC Owner's Manual

Monitor Panel

The water system features a water/waste system monitor
panel which senses the amount of water left in the potable
water tank system. It is located at the ship's main electrical
control panel in the aft starboard salon.
To use the panel, press the switch in toward the freshwater
tank position and hold. The amount of potable tank water
will be displayed. The sender for the fresh water monitor is
located on the top of the starboard fresh water tank which
is located in the engine room. Since both fresh water tanks
drain at approximately the same rate only a single system
sender is needed to monitor the fresh water remaining in
both fresh water tanks.
The key switch is used for overboard discharge. Read
and understand the section on using the macerator in the
waste system before attempting to operate the overboard
discharge system. Laws in many locals prevent the use of
overboard discharge. A person could be severely fi ned so know the
restrictions before using the macerator pump-out.
Do Not Use Waste
Pump-Out Before
Knowing The Local
Laws/Restrictions
Sanitizing Water System
If the vessel has been in a storage condition or you suspect
the water system may be contaminated, then the system
should be sanitized.
You can purchase a water treatment kit with ingredients
that will sanitize the system. Follow the directions with
the treatment kit. If a water treatment kit is not available
follow these steps to sanitize the water system.
1. Make sure the water tank is pumped until empty. Shut
off the water pressure breaker at the 12 volt ship's panel. Do
not run the fresh water pump dry.
2. Use the potable water system disinfection information
and chart located on the next page.
3. Follow the step by step procedure using the supplementary
chart as needed to mix the ingredients.
82
Chapter 4