Regal 53 SC Owner's Manual page 366

Table of Contents

Advertisement

UPHOLSTERY
Cockpit vinyl requires periodic cleaning to maintain a
neat appearance and to prevent the build up of dirt and
contaminants that may stain and reduce the vinyl life if
they are not removed. The frequency of cleaning depends
on the amount of use and conditions to which the vinyl
is subjected.
Most common stains can be cleaned using warm, soapy
water and clear rinses. Scrubbing with a soft bristle brush
will help loosen soiled material from embossed surfaces
and under welting. If the stains are not removed with the
above method use a mild cleaner such as Fantastic. This
cleaner should be used only as needed and not the normal
means.
With more stubborn stains, rubbing alcohol or mineral
spirits may be tried cautiously. Widespread solvent use can
severely damage or discolor vinyl.
Try to remove stains immediately before they have a chance
to penetrate the surface of the vinyl.
Powdered abrasives, steel wool, or industrial strength clean-
ers are not recommended for cleaning our vinyl. Lacquer
solvents will cause immediate damage. Dilute chlorine
bleach before using. Do not wax the vinyl as it may cause
cracking. Always wear protective gloves and make sure
there is suffi cient ventilation when cleaning vinyl. Wear
eye protection.
Remember that suntan oil will damage vinyl. Use suntan
lotion instead of suntan oil. Exposure to the sun is a natural
enemy of vinyl upholstery. For maximum life, use a cockpit
cover when the vessel is moored, docked or stored.
Ballpoint Pen Removal Instructions
1. Wipe the stain off with ethanol (rubbing alcohol).
2. Prepare a solution of 50% non-chlorinated bleach, 50%
water.
3. Place a thin line of tissue over the ink stain.
4. Apply the non-chlorinated bleach solution to the tissue.
Be sure not to saturate the tissue.
5. Cover tissue with polyethylene fi lm (plastic wrap) to
prevent the non-chlorinated bleach solution from drying.
6. Check on stain repeatedly.
7. Do not leave the non-chlorinated beach solution on for
more than 1 hour.
When the stain looks almost gone, remove the tissue and
wash the stain with water.
9. To neutralize the bleached area, place tissues on the
bleached area and apply 15% hydrogen peroxide solution.
10. Leave on for 30 minutes, & then remove the tissues.
11. Remove the peroxide residue with water.
20
Chapter 8

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents