Windlass System - Regal 53 SC Owner's Manual

WINDLASS SYSTEM

CLEAT
CHAIN
LOCK
(STOPPER)
FOOT
SWITCH
UP
FOOT
SWITCH
DOWN
WINDLASS
SWITCH
WINDLASS COMPONENTS
OFF
ON
SWITCH SHOWN IN
"ON" POSITION
As seen in the illustration above open the center deck
locker to gain access to the windlass switch. The switch
"off " position is at 12 o' clock. With the switch "on"
position (shown above) at 3 o'clock the foot switches are
energized. If the foot switches have no power check the
breaker located in aft stateroom electronics locker.
ANCHOR
SHANK
CHAIN
ROPE
LOCKER
ROPE
WINDLASS
The windlass is used to au-
tomatically raise and lower
the anchor. Before attempt-
ing to lower the rope/chain
rode check the rope locker
for tangled rope or chain.
On earlier models, remove
the safety lanyard from the
anchor chain.
The chain lock (stopper) is used to hold the chain portion
of the anchor line assembly and does not effect the ny-
lon anchor line. Before using the windlass make sure the
chain lock (stopper) is positioned with the lever pointing
toward the stern.
The chain lock "dances" or ratchets over the chain while
the process of retrieving the anchor rode is underway.
The chain stopper will lock the chain once the anchor is
completely retrieved into the bow pulpit chute.
CHAIN LOCK
(STOPPER)
Note: Make sure the chain lock (stopper) is positioned to engage
the chain once the anchor is retrieved. This prevents the chain from
paying out under abnormal conditions or when a weakened gipsy
clutch condition exists.
105
Systems
TO BOW
CHAIN LOCK LEVER
POSITIONED TO
ENGAGE CHAIN
TO STERN