Regal 53 SC Owner's Manual page 79

MASS COMBI BATTERY CHARGER REMOTE DISPLAY PANEL
A
Located inside the salon main ship's cabinet is a remote display panel for the optional mass combi battery charger.
This display shows current DC load, charger state mode, and charger mode status. If an optional inverter sub panel
is installed the display indicates inverter mode, AC input, and battery voltage.
Refer to the function letter above and descriptions below.
A. Charger Mode- Displays the DC charge current as a
percentage of the maximum current.
Inverter Mode- Displays the AC power as a percentage
of the maximum power.
B. Charge Cycle- Displays the state of charge, bulk,
absorption or fl oat.
Invertor Mode- Displays the approximate battery voltage.
C. Inverter LED- Green LED: the mass combi is oper
ating in inverter mode
Red: an error is detected.
D. AC Input- Illuminates when the incoming AC power
is available.
B C
G
E. Failure LED- When illuminated red, a failure is
A
detected.
F. On/Off Switch- This switch will not operate if the
main switch on the bilge component is set to "off ".
G. Charger LED- Green; the Mass Combi is operating
in charger mode. Red; an error is detected.
Note that when the bilge mounted face panel switch is
turned to the off position the remote panel on switch
will be inoperative.
27
D E
F
Systems