Regal 53 SC Owner's Manual page 422

Chapter 8
WINDLASS
The typical windlass requires periodic maintenance to
keep it in top running condition. Every 6 months the
manufacturer recommends that the unit be disassembled
and all the above deck parts be washed down with fresh
water. Lightly oil (SAE 10) the seal, shaft, cone clutch and
spline. Ensure that the base, below the gipsy, is cleaned well
and the sealing ring is checked. Grease the threads on the
chain pipe cover and stripper screws before re-assembly.
The bearing is self lubricating and should not require
servicing.
Below the deck check regularly the condition of the
motor/gear box and terminals and re-apply grease when
necessary. The motor/gear box is two part epoxy painted
to protect it against corrosion as it is constructed of steel
and lives in the harshest environment on your craft. If
corrosion on the motor is evident, clean and repaint with
marine grade oil based enamel paint.
Note: Refer to the windlass operator's manual for additional
maintenance information.
WARNING
!
TO PREVENT BODILY INJURY
REMOVE THE CHAIN FROM WINDLASS
BEFORE PERFORMING MAINTENANCE.
76