Plumbing Connectors - Regal 53 SC Owner's Manual

PLUMBING CONNECTORS

Plumbing connections to the red and blue fresh water lines
require special instructions when they are to be removed or
replaced due to leaks. Be sure to turn off the water for that
circuit at the manifold before starting any plumbing repairs.
1. To remove a tee, 90 degree, or straight connector fi tting
fi rst remove the cap on the end of the fi tting by using a
slotted screwdriver. Insert the screwdriver in the cap slot
and turn 90 degrees. Cap will release from the fi tting.
Slotted
Screwdriver
Cap
2. Push the connector and collar together. Hold the
collar next to the connector with your fi nger. Pull and the
connector/collar will release itself from the water line.
Hold End Of Fitting
With Fingers And Pull
Connector Free Of
Supply Line
Cosmetic Care & Maintenance
To reinstall a plumbing connection to a water line make
sure the line is cut off square and the end is smooth. This
will aid in ensuring a leakproof connection.
1. Install the cap on the supply line. You may need to use a
slotted screwdriver to remove the cap from a new fi tting.
2. Simply push the fi tting on to the supply line until pressure
is felt. This ensures it is completely in the fi tting.
3. Push the cap on the collar until it snaps in place.
Turn on the water pressure and check for leaks.
Note: With the connector in place, a movement between
the line and connector is normal.
Fitting
59