Regal 53 SC Owner's Manual page 473

Alarms and Messages
Your VHF marine radio at times may generate an alarm
or system message on the display.
Battery Alarm- When the radio senses a voltage greater
than 15.8 Vdc or less than 10 Vdc, "high voltage" or "low
voltage" is displayed on the radio display screen. Check
the wiring if this should occur.
Main in Use- When the primary VHF 200 or VHF 200i
unit is being used, "main in use" is displayed on the screen
of all remote GHS 10 or GHS 10i handsets. The screen
returns to normal thrre seconds after the last input on the
primary station.
WX(weather alert)- If you set the WX alarm and an incom-
ing weather alert is detected, the radio automatically tunes
to the WX channel that is broadcasting the alert.
GPS Data Alarm- When GPS data from a NMEA net-
work or position data you entered manually is over four
hours old, the alarm tone beeps and "data is over 4 hours
old" is displayed on the screen.
• Select ignore to disregard the alarm and to turn off
the beeping alarm. When you take no action over 3
minutes, ignore is selected automatically.
• Select set to enter a new position.
Invalid GPS Data Alarm- When GPS data from a NMEA
network or position data you entered is over 23.5 hours
old, "data is invalid" is displayed on the screen. The radio
will transmit position data that is more than 23.5 hours
old.
• Select ignore to discard the old position data. The
screen displays "NO GPS INFO" on the home
screen. When you take no action after 3 minutes, ig-
nore is selected automatically..
VHF MARINE RADIO
• Select set to enter a new position.
Position Tracking- After 5 consecutive failed attempts to re-
quest position information from a vessel, "NO POS FOR
(VESSEL NAME) is displayed on the screen.
• Select retry to reattempt the position request.
• Select remove to discontinue calling the vessel. When
you take no action after three minutes, remove is se-
lected automatically
Note: Refer to the VHF marine radio operator's manual
for further information.
48
Chapter 9