Helm Displays - Regal 53 SC Owner's Manual

HELM DISPLAYS/COMPONENTS
Engine Shutdown Gauge-Fire Ext. System
the alarm will sound and the ignition system will be
instantaneously interrupted. Should this occur shut down
any electrical system components along with closing any
open hatches. Once the vessel is determined to be clear
of fi re the engines can be started with the switch in the
override position.
Manual Fire Extinguisher Shutdown-
"FIRE"
HANDLE
SAFETY
PIN
the compartment closed for a period of time suffi cient to
permit the agent to soak all areas of the protected space.
This allows hot metals and fuel time to cool. Refer to the
manufacturer's owner's manual for additional information.
This helm mounted
display unit provides the
operator with a system
status of a charged or
uncharged condition
with an audible alarm.
With the ignition switch
on a green light indicates
the fire extinguisher
system is normal. If the
system should discharge
The manual fire shutdown is
located in the cockpit. If a fi re has
started in the engine compartment
find the system manual cable
assembly. Remove the safety pin
from the "Fire T Handle" and pull
fi rmly on the "Fire" handle which
will activate the fi re extinguisher
unit in the engine compartment.
A loud "rushing air" sound may
be heard. Complete discharge
will take several seconds. Keep
Engine & Controls
High Water Alarm
Using a bilge fl oat sensor this helm
display determines a high water
situation and sends a signal to the
dash alarm. This may indicate that
a large amount of water has entered
the hull or there is a leak in the engine
water circulation system and the bilge
pump cannot evacuate water overboard fast enough or has
failed to operate. Periodically manually activate the bilge
pump to check operation. The bilge pump sensor is located
in the engine room setting a few inches above normal bilge
water accumulation.
7